sink mark

常见例句

双语例句

• Too high switch point: empty part, weld line, sink mark, and small.
  转压点太高：产品充模不足，熔接痕，凹陷，尺寸偏小等。
• How much pressure? thicker section is it possible to occur sink mark ?
  压力有多大？ 厚的区域是否有可能出现缩水的现象？
• The generation processes of several typical injection molding defects, such as jetting and snake flow , sink mark and bubble, were directly observed and recorded.
  观察并记录了典型成型缺陷产生过程，包括喷射与蛇形流动、缩痕、气泡等，提出了解决这些成型缺陷的方法。2。

权威例句

• The spit sink left a permanent mark on the floor.
  FORBES: A Place of Excellence
返回 sink mark